Guide

Conditional access in plain words

Conditional access is a set of sign-in rules: who may log in, from where and on what device.

What to do

  • Block sign-ins from countries where nobody works.
  • Require two-step log-in outside the office.
  • Require a managed device for admin work.
  • Test each rule in report-only mode before enforcing it.

Why it matters

Two-step log-in asks who you are. Conditional Access also asks where you are, what device you use and how risky the sign-in looks, and then decides whether to let you in, ask for more proof or block you. It is how you make two-step log-in stick, block old sign-in methods and keep admin work on trusted machines.

Conditional Access needs Microsoft Entra ID P1, which is part of Microsoft 365 Business Premium and the E3 and E5 plans. Without it, security defaults give you a fixed set of the most important rules.

How to check it yourself

In the Microsoft Entra admin center, the Conditional Access area lists every policy and its state: on, off or report-only. Open each one and read who it applies to, which apps, which conditions, and what it grants or blocks. Look closely at exclusions. A policy that excludes a whole group often protects less than its name suggests.

The sign-in logs show which policies applied to each sign-in and whether they passed. The What If tool lets you test a made-up sign-in against your policies without anyone being blocked.

Check also that security defaults are off if you have policies, and that no policy has sat in report-only mode for months. A rule that was tested and then forgotten protects nobody.

A sensible first set of policies

Microsoft offers ready-made templates for most of these. Exclude your two emergency access accounts from every policy, so a mistake cannot lock everyone out. Run each new policy in report-only mode for a week or two, read the results in the sign-in logs, and then switch it on.

  • Require two-step log-in for all users.
  • Require phishing-resistant two-step log-in, such as a security key, for admin roles.
  • Block legacy authentication, which cannot handle a second step.
  • Block sign-ins from countries where nobody works, using named locations.
  • If you manage devices with Intune, require a compliant device for admin work.

What to tell your insurer

Insurers rarely ask about Conditional Access by name. They ask whether two-step log-in is enforced, whether remote access is protected and whether old sign-in methods are blocked. Your policies are the evidence. Count only policies that are switched on; one in report-only mode does not enforce anything yet.

How Ciras checks it

Ciras reads your Conditional Access setup with read-only access and checks the Microsoft controls that apply to your licences. The report explains in plain language what is enforced and what is not. With the AI fix service, a proposed policy is written out in plain words, and nothing changes until a person approves it.

Questions

Can we use security defaults and Conditional Access together?

No. You must switch security defaults off before you can enable Conditional Access policies. Have your replacement policies ready first, so there is no gap.

What happens if a policy locks us out?

That is what the emergency access accounts are for. Sign in with one, fix the policy, and then check why report-only mode did not catch it.

Does blocking countries stop attackers?

It cuts noise, but attackers can route traffic through a country you allow. Treat it as one layer on top of two-step log-in, not a replacement.

What about staff who travel?

Add the destination to a named location for the length of the trip, or put the traveller in a group with its own rule. Remove the exception when they are back.

Updated 2026-11-11

Next

See where you stand.

Make an account, sign in read-only, and read your own report half a minute later. 499 kr. for one scan.